Operator control
7.2 Passwords
Modular Safety System 3RK3
212 System Manual, 10/2008, 926 2530-02 DS 02
Dialog box "Edit" > "Password for test mode"
● This password is requested every time you switch to test mode via the "Target system" >
"Test mode" menu command.
● You can assign/change the password for changing to test mode.
Note
If you have forgotten the password for changing to test mode, you must restore the
factory settings of the MSS. You can do this on the safety relay or by means of a
command in the MSS ES.
Prompt for passwords
● Enter password
– The "Enter password" dialog appears if you open a password-protected configuration,
for example.
– Enter the password and confirm with "OK".
● Password forgotten:
– If you have forgotten the project access password, you can open the configuration
write-protected. To do this, click on the "Cancel" button. An online configuration can
only be opened if the protection level has been set to "Write protection".
To Next Page
Loading...
