Siemens SIRIUS M200D - Page 150

Diagnostics
7.3 Diagnostics via data sets
M200D PROFIBUS/PROFINET
150 Manual, 08/2014, A5E01577426A/RS-AA/004
Maximum pointer (DS 96)
The extreme values of individual values measured in the elapsed time are stored in the
maximum pointers. Maximum pointers can be deleted or set to "0" by the user with the
command "Delete maximum pointers".
The following data is saved in DS 96 (Page 207):
● Number of motor overload trips
● Operating hours motor current = 18 to 49.9% of I
e
● Operating hours motor current = 50 to 89.9 % of I
e
● Operating hours motor current = 90 to 119.9 % of I
e
● Operating hours motor current = 120 to 1000 % of I
e
● Maximum tripping current I
A max
(%)
● Maximum tripping current I
A max
(rms)
● Phase current I
L1 max
(rms)
● Phase current I
L2 max
(rms)
● Phase current I
L3 max
(rms)
● Phase current I
L1 min
(rms)
● Phase current I
L2 min
(rms)
● Phase current I
L3 min
(rms)
● Phase current I
L1 max
(%)
● Phase current I
L2 max
(%)
● Phase current I
L3 max
(%)
● Phase current I
L1 min
(%)
● Phase current I
L2 min
(%)
● Phase current I
L3 min
(%)
● Maximum heat sink temperature (only on sDSSte/sRSSte 12 A)