Appendix
A.1 Data formats and data sets
M200D PROFIBUS/PROFINET
202 Manual, 08/2014, A5E01577426A/RS-AA/004
344 5.0 Bit (1 = active) Input 1 All All
345 5.1 Input 2 All All
346 5.2 Input 3 All All
347 5.3 Input 4 All All
348 5.4 Input tripping All All
349 5.5 Input tripping limit position CW rotation All All
351 5.6 Input warning All All
350 5.7 Input tripping limit position CCW rotation All All
354 6.3 Bit (1 = active) Sensor supply overload All All
361 6.4 Trip reset executed All All
362 6.5 Trip reset not possible All All
363 6.6 Maximum pointer deleted All All
317 6.7 Electronics supply voltage too low All All
303 7.0 Bit (1 = active) Bus error All All
356 7.1 CPU/master STOP All All
357 7.2 Automatic mode All All
358 7.3 Manual bus mode (remote control) All All
359 7.4 Manual local mode (local control) All All
360 7.6 Manual operation connection abort All All
355 7.7 Process mapping error All All
364 8.0 Bit (1 = active) Parameter assignment active All All
365 8.1 Invalid parameter value All All
366 8.2 Parameters cannot be changed in ON state All All
368 8.3 Parameters disabled CPU/master active All All
384 8.4 No external start-up parameters received All All
379 9.0 Bit (1 = active) Self-test active All All
380 9.1 Self-test ok All All
381 9.2 Self-test error All All
369 9.3 Factory settings restored All All
367 10 Object No. (low byte) (= errored parameter
number)
All All
11 0x00 Object No. (high byte) All All
1484 12.4 Bit (1 = active) Temperature sensor deactivated All All
1405 14.0 Bit (1 = active) Cold start active All All
1406 14.1 Cold start tripping All All
To Next Page
Loading...
