Simplex 4100U Installation & Maintenance

F-1
This appendix describes the following:
• It lists devices that have been approved as compatible devices for use with the
4100A/4100U FIP.
• It lists the devices approved for use with the IDNet and shows the number allowed
per loop.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
List of Approved Devices
F-1
Compatible Detectors, IDNET
F-4
Compatible Addressable Field Devices, IDNet
F-5
Simplex Range - Conventional Detectors
4098-9413 Heat detector Type A
4098-9414 Heat detector Type B
4098-9415 Heat detector Type C
4098-9416 Heat detector Type D
2098-9201 Photoelectric smoke detector
2098-9576 Ionisation smoke detector
4098-9618EA Heat detector Type A
4098-9619EA Heat detector Type B
4098-9621EA Heat detector Type D
4098-9621A Heat detector Type C
4098-9601EA Photoelectric smoke detector
4098-9603EA Ionisation smoke detector
Continued on next page
Appendix F
Compatible Actuating Devices
Introduction
In this Chapter
List of Approved Devices

Simplex 4100U Specifications

General

Control Panel Type	Addressable Fire Alarm Control Panel
Display	LCD
Power Supply	120/240 VAC, 50/60 Hz
Max Signaling Line Circuits (SLC)	2
Operating Temperature	0°C to 49°C (32°F to 120°F)
Humidity Range	10% to 93% non-condensing
Network Capability	Yes
Communication Protocol	RS-232, RS-485
Battery Backup	24 VDC
NAC Outputs	4
Signaling Line Circuits (SLCs)	2
Power Supply Current	3.0 A
Max Notification Appliance Circuits (NAC)	4
Max Releasing Circuits	4
Max Relay Circuits	4
Communication Ports	RS-232, RS-485