Simplex 4100U Installation & Maintenance

3-29
4100 host panel and remote locations. This chapter describes the transponder installation
procedure for all MINIPLEX systems in non-4100U systems.
Refer to the page number listed in this table for information on a specific topic.
Topic See Page #
Introduction to MINIPLEX Systems (Non-4100U)
3-30
MINIPLEX System Components (Non-4100U)
3-32
MINIPLEX System Guidelines (Non-4100U)
3-34
Installing Modules into Cabinets (Non-4100U)
3-35
MINIPLEX Wiring (Non-4100U)
3-39
Chapter 3
Installing 4100 MINIPLEX Components (Non-4100U)
Introduction
In this Chapter

Simplex 4100U Specifications

General

Control Panel Type	Addressable Fire Alarm Control Panel
Display	LCD
Power Supply	120/240 VAC, 50/60 Hz
Max Signaling Line Circuits (SLC)	2
Operating Temperature	0°C to 49°C (32°F to 120°F)
Humidity Range	10% to 93% non-condensing
Network Capability	Yes
Communication Protocol	RS-232, RS-485
Battery Backup	24 VDC
NAC Outputs	4
Signaling Line Circuits (SLCs)	2
Power Supply Current	3.0 A
Max Notification Appliance Circuits (NAC)	4
Max Releasing Circuits	4
Max Relay Circuits	4
Communication Ports	RS-232, RS-485