Simplex 4100U - Step 2. Mounting Media Cards to the NIC; Overview; Media Card Mounting; Figure 5-6. Media Card Mounting

5-9
The 4100-6014 Network Interface Card (NIC) uses media cards to connect to other NICs.
This section describes how the media cards are mounted onto NICs.
NICs connect to each other via the three types of media cards. The types of media cards
in the right and left ports are determined by the type of wiring that is being used across
cards.
Connect P1 on the wired media card, or J1 on the modem or fiber media cards, to P5 (the
left port) on the NIC.
To connect a second media card to the same NIC, connect it as described above, but use
P6 (the right port) on the NIC. Note that any two types of media cards can be connected
to the same NIC.
Figure 5-6. Media Card Mounting
Step 2. Mounting Media Cards to the NIC
Overview
Media Card
Mounting
MEDIA CARDS
4100-6014 NETWOR
K
INTERFACE CARD
40-PIN
CONNECTION
(MEDIA CARD
P1 OR J1 TO
NIC P5)
40-PIN
CONNECTION
(MEDIA CARD
P1 OR J1 TO
NIC P6)
STANDOFFS FIT INTO HOLES