Sonardyne 8270 - Tone Burst Sequence; Table 7-2 - ANT Keypad Sequence of Operation

WSM6 Manual
Document Ref: UM-8270-000
Issue: A Rev 0
Section 7
October 2011 85
7.10.1 Tone Burst Sequence
Switch the ANT OFF, then ON and key in the following sequence of commands on the ANT keypad
([] indicates keypad keys):
Table 7-2 – ANT Keypad sequence of operation
Keypad Key Command Comments
[ON]
[2]
PULSE
[2]
SET
[2]
FREQ
[2], [3], [9], [2], [3]
Interrogation frequency for HPR
channel B33
[ENTER]
[4]
PW Pulse width set in ms
[1], [0], [ENTER]
[5]
TRIG
[2]
SET TRIG IN
[2]
REP PERIOD In ms
[7], [5], [0], [ENTER]
[1]
EXIT
[3]
SET TRIG OUT
[2]
PULSE WIDTH
[1], [ENTER]
PULSE WIDTH In ms
[3]
O/P DELAY
[0], ENTER
O/P DELAY In ms
NOTE
When a delay of 29.5ms is required for the ‘scope trigger’, the O/P Delay – in ms – can
be entered instead of 0
[1]
EXIT
[1]
EXIT
[1]
EXIT
[5]
START