Configuring NTP Autokey
Note: When you configure NTP Autokey, you must disable the NTP Service first,
and then re-enable it after Autokey configuration is completed. See "Dis-/En-
abling NTP" on page80.
To configure NTP Autokey:
1.
Navigate to MANAGEMENT > NETWORK: NTP Setup.
2.
In the NTP Services panel, click the GEAR icon in the top-right corner.
3.
The Edit NTP Services window will display.
4.
Click the Autokey tab.
5.
Check the Autokey box.
6.
Fill in the Passphrase field by creating a passphrase (for a Trusted server—see Certificate
Type below), or by using the existing passphrase of your trusted server (for Server and
Client certificates).
7.
Select the Certificate Type for your server, by clicking the appropriate radio button for
Server, Client, or Trusted.
T R U S T E D S e r v e r :
Before a server can be designated Client or Server status, one server must be designated as
Trusted. When designating a server as Trusted:
1. Choose the Trusted radio button.
2. Click the Submit button.
A Groupkey is then generated for the network. This Groupkey will be pasted into the Group-
key box to designate another server on the network as Client or Server.
2.7 Configuring Network Settings
CHAPTER 2 • VersaSync User Manual Rev. 6.0
95
To Next Page
Loading...
