USB on-the-go full-speed (OTG_FS) RM0090
1256/1731 DocID018909 Rev 11
• Host port CSRs
• Host channel-specific registers
• Device-mode registers
• Device global registers
• Device endpoint-specific registers
• Power and clock-gating registers
• Data FIFO (DFIFO) access registers
Only the Core global, Power and clock-gating, Data FIFO access, and host port control and
status registers can be accessed in both host and device modes. When the OTG_FS
controller is operating in one mode, either device or host, the application must not access
registers from the other mode. If an illegal access occurs, a mode mismatch interrupt is
generated and reflected in the Core interrupt register (MMIS bit in the OTG_FS_GINTSTS
register). When the core switches from one mode to the other, the registers in the new mode
of operation must be reprogrammed as they would be after a power-on reset.