DocID018909 Rev 11 1593/1731
RM0090 Flexible memory controller (FMC)
1669
Configuration registers
The FMC can be configured through a set of registers. Refer to Section 37.5.6, for a
detailed description of the NOR Flash/PSRAM controller registers. Refer to Section 37.6.8,
for a detailed description of the NAND Flash/PC Card registers and to Section 37.7.5 for a
detailed description of the SDRAM controller registers.
37.4 External device address mapping
From the FMC point of view, the external memory is divided into 6 fixed-size banks of
256 Mbyte each (see Figure 455):
• Bank 1 used to address up to 4 NOR Flash memory or PSRAM devices. This bank is
split into 4 NOR/PSRAM subbanks with 4 dedicated Chip Selects, as follows:
– Bank 1 - NOR/PSRAM 1
– Bank 1 - NOR/PSRAM 2
– Bank 1 - NOR/PSRAM 3
– Bank 1 - NOR/PSRAM 4
• Banks 2 and 3 used to address NAND Flash memory devices (1 device per bank)
• Bank 4 used to address a PC Card
• Bank 5 and 6 used to address SDRAM devices (1 device per bank).
For each bank the type of memory to be used can be configured by the user application
through the Configuration register.
To Next Page
Loading...
Need help?
General
