DocID018909 Rev 11 1377/1731
RM0090 USB on-the-go high-speed (OTG_HS)
1529
Endpoint status/interrupt
The device endpoint-x interrupt registers (DIEPINTx/DOPEPINTx) indicate the status of an
endpoint with respect to USB- and AHB-related events. The application must read these
registers when the OUT endpoint interrupt bit or the IN endpoint interrupt bit in the core
interrupt register (OEPINT bit in OTG_HS_GINTSTS or IEPINT bit in OTG_HS_GINTSTS,
respectively) is set. Before the application can read these registers, it must first read the
device all endpoints interrupt register (OTG_HS_DAINT) to get the exact endpoint number
for the device endpoint-x interrupt register. The application must clear the appropriate bit in
this register to clear the corresponding bits in the DAINT and GINTSTS registers.
The peripheral core provides the following status checks and interrupt generation:
• Transfer completed interrupt, indicating that data transfer has completed on both the
application (AHB) and USB sides
• Setup stage done (control-out only)
• Associated transmit FIFO is half or completely empty (in endpoints)
• NAK acknowledge transmitted to the host (isochronous-in only)
• IN token received when Tx-FIFO was empty (bulk-in/interrupt-in only)
• OUT token received when endpoint was not yet enabled
• Babble error condition detected
• Endpoint disable by application is effective
• Endpoint NAK by application is effective (isochronous-in only)
• More than 3 back-to-back setup packets received (control-out only)
• Timeout condition detected (control-in only)
• Isochronous out packet dropped without generating an interrupt
To Next Page
Loading...
Need help?
General
