Black plate (126,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
3-8 Instruments and controls
& Canceling the function for
meter/gauge needle move-
ment upon turning on the
ignition switch
S03AD02
Type A, B and C combination meter
Type D and E combination meter
It is possible to activate or deactivate the
movement of th e meter needles a nd
gauge needles that takes place when the
ignition switch is turned to the “ON”
position.
1. Turn the ignition switch to the “LOCK”/
“OFF” or “Acc” position.
2. Press the trip knob to show “
”/“ ”
or “
”/“ ” on the odometer/trip meter
display.
The display can be switched as shown in
the following sequence by pressing the
trip knob.
Type A, B and C combination meter:
*: “ ” or “ ”, and “ ” or “ ” cannot
be displayed when the ignition switch is
in the “ON” position.
Type D and E combination meter:
*: “ ” or “ ” cannot be displayed when
the ignition switch is in the “ON” posi-
tion.
3. To change the current setting, press
the trip knob for at least 2 seconds.
/ : Activated
/ : Deactivated
NOTE
Your vehicle’s initial movement setting
of the meter/gauge needles has been
set for activation “
”/“ ” at the time
of shipment from the factory.
To Next Page
