Subaru FORESTER 2012 - Radio Data System (RDS) on FM (Type A, B, D and E)

Black plate (202,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
5-16 Audio
! Local seek function (type A, B, D
and E audio)
S05AW0206
Type A, B and E
audio
Type D audio
You can turn the local seek function on or
off during FM, MW or LW reception by
pressing the “RDS” button for at least 1.5
seconds.
& Radio Data System (RDS) on
FM (type A, B, D and E)
S05AW09
RDS is a system in which inaudible digital
information is transmitted in addition to
normal FM radio broadcasts. Your car
radio uses the RDS information to offer
you many benefits.
! Alternative Frequencies (AF)
S05AW0901
If the vehicle moves beyond the area of
the station that the radio is receiving and
subsequently enters an area where the
same station is available on a different
frequency, the radio automatically tunes in
that frequency. Push and hold the “RDS”
button to change the ON and OFF mode
of the alternative frequency (AF) search-
ing function. The default setting is ON.
! Regional (REG) setting
S05AW0904
When the vehicle moves from one area to
another area while receiving an area-
specific local station, this function selects
whether the radio continues to receive the
same station or tunes to a local station of
the new area.
! VOL ADJUST/Interrupt volume
setting
S05AW0907
It is possible to preset the volume that the
set will use when it interrupts playback
with broad casts of traffic inform ation,
news bulletins or emergency announce-
ments.
If you select the “VOL ADJUST / Interrupt
volume” setting, the preset interruption
volume can be adjusted.
NOTE
. If the preset interruption volume is
lower than the current volume when
interruption reception occurs, the vo-
lume does not change to the preset
interruption level. (It remains at the
current level.)
. When an interruption reception
finishes, the volume returns to the
original level.
! Traffic information (T.I.) (type A, B,
D and E audio)
S05AW0902
Type A and B audio
Type D audio
Type E audio
When a station begins broadcasting traffic
information, this function causes the set to
automatically receive it. If the driver is
listening to another audio source, the set
breaks into that playback with the traffic
information.
It is possible to turn the traffic information
break-in function ON/OFF by pressing the
“T.I/NEWS” button briefly.
When the audio power is OFF, pressing
the “T.I/NEWS” button causes the audio
power to turn ON and the traffic informa-
tion break-in function to be turned ON.
The “TA” illuminates on the display (for
“traffic announcements”) while the set is
actually receiving traffic information.