Black plate (388,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
11-38 Maintenance and service
Hill start assist system (MT
models)
S11BF
Ensure that the Hill start assist system
operates properly under the following
circumstances:
1. Stop the vehicle on an uphill grade by
depressing the brake pedal and clutch
pedal, with the engine running.
2. Make sure that the vehicle does not
move backward even after the brake
pedal is released.
3. Then make sure the vehicle starts
climbing the grade by following the normal
starting procedures.
If the Hill start assist system does not
operate as described above, we recom-
mend that you contact your SUBARU
dealer.
Replacement of brake pad
and lining
S11AT
Each disc brake has audible wear indica-
tors on the brake pads. If the brake pads
wear close to their service limit, the wear
indicator makes a very audible scraping
noise when the brake pedal is applied.
If you hear this scraping noise each time
you apply the brake pedal, we recommend
that you have the brake pads serviced by
your SUBARU dealer as soon as possible.
CAUTION
If you continue to drive despite the
scraping noise from the audible
wear indicator, it will result in the
need for costly brake rotor repair or
replacement.
& Breaking-in of new brake
pads and linings
S11AT01
When replacing the brake pad or lining,
we recommend that you use only genuine
SUBARU parts. After replacement, the
new parts must be broken in as follows.
WARNING
A safe location and situation should
be selected for break-in driving.
! Brake pad and lining
S11AT0101
While maintaining a speed of 50 to 65
km/h (30 to 40 mph), step on the brake
pedal lightly. Repeat this five or more
times.
! Parking brake lining
S11AT0102
CAUTION
Pulling the parking brake lever too
forcefully may cause the rear
wheels to lock. To avoid this, be
certain to pull the lever up slowly
and gently.
1. Drive the vehicle at a speed of
To Next Page
Loading...
