Black plate (165,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
vehicle speed (longer when the vehicle
speed is low; shorter when the vehicle
speed is high).
When you subsequently shift the trans-
mission into reverse, the rear wiper will
automatically switch to continuous opera-
tion. When the transmission is shifted to a
position other than reverse, the rear wiper
will return to intermittent operation.
! Washer
S03AM0202
To wash the rear window while the rear
wiper is operating, turn the knob upward to
the “
” position. The washer fluid sprays
until you release the knob.
To wash the rear window when the rear
wiper is not in use, turn the knob down-
ward to the “
” position. The washer fluid
sprays and the wiper operates until you
release the knob.
NOTE
When the amount of washer fluid is
getting low, the rear washer fluid will
first be stopped. This means that the
amount of washer fluid is low, and it
should be added immediately.
Headlight washer (if
equipped)
S03AV
Withtheignitionswitchinthe“ON”
position and the headlight switch in the
“
” position, the windshield washer
operates first when you press the wind-
shield washer button. If you conti nue
pressing the button for more than 1
second, the headlight washer then oper-
ates together with the windshield washer.
The windshield washer stops spraying
washer fluid as soon as you release the
windshield washer button. The headlight
washer sprays the washer fluid for ap-
proximately 1 second and then stops
automatically.
CAUTION
Do not operate the washer if the
washer fluid tank is empty. This may
cause overheating of the washer
motor. Check washer fluid level
frequently, such as at fuel stops.
NOTE
. When the area around the nozzle
cover of the headlight washer is frozen,
remove the ice before use.
. When the headlights are very dirty,
perform the operation repeatedly.
Instruments and controls 3-47
3
To Next Page
Loading...
