Black plate (369,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
4. While depressing the brake pedal,
perform the following:
(1) Push the rear window defogger
switch to ON.
(2) Turn the headlight switch to the
position.
(3) Push the rear window defogger
switch to OFF.
(4) Turn the headlight switch to OFF.
(5) Repeat steps (1) through (4) once
more, and go to next step.
(6) Release the brake pedal.
5. Preheating indicator light will blink for
approximately 5 seconds when the data
has been reset successfully.
NOTE
. Each step between (1) and (6) must
be operated within 4 seconds.
. If the resetting procedure was un-
successful, repeat steps 1. through 5.
after performing the following items.
– Wait for 30 seconds with the
engine idling.
– Turn the engine off, wait for 15
seconds and then restart the en-
gine.
& Recommended grade and
viscosity
S11AE03
CAUTION
Use only engine oil with the recom-
mended grade and viscosity.
Refer to “
s12aa12Engine oil” F12-6.
NOTE
Engine oil viscosity (thickness) affects
fuel economy. Oils of lower viscosity
provide better fuel economy. However,
in hot weather, oil of higher viscosity is
required to properly lubricate the en-
gine.
& Synthetic oil
S11AE05
You can use synthetic engine oil that
meets the same requirements given for
conventional engine oil. When using
synthetic oil, you must use oil of the same
classification, viscosity and grade shown
in this Owner’s Manual. Refer to “
s12aa12En-
gine oil” F12-6. Also, you must follow the
oil and filter changing intervals shown in
the maintenance schedule. Refer to “
s11aa-
Maintenance and service 11-19
– CONTINUED –
11
To Next Page
Loading...
