Subaru FORESTER 2012 - Light (if Equipped)

Black plate (136,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
3-18 Instruments and controls
running, it may indicate that there is a
problem or potential problem somewhere
in the emission control system and that
service is required. The OBD system also
assists your service technician in properly
diagnosing any malfunction.
CAUTION
If the malfunc tion indicator la mp
illuminates while you are driving,
we recommend that you have your
vehicle checked/repaired by your
SUBARU dealer as soon as possi-
ble. Continued vehicle operation
without having the emission control
system checked and repaired as
necessary could cause serious da-
mage, which may not be covered by
your vehicle’s warranty.
! If the light illuminates steadily
S03AE260101
If the light illuminates steadily while driving
or does not turn off after the engine starts,
an emission control system malfunction
has been detected.
We recommend that you have your
vehicle checked by an authorized
SUBARU dealer immediately.
! If the light is blinking
S03AE260102
If the light is blinking while driving, an
engine misfire condition has been de-
tected which may damage the emission
control system.
To prevent serious damage to the emis-
sion control system, you should conform
to the following instructions.
. Reduce vehicle speed.
. Avoid hard acceleration.
. Avoid steep uphill grades.
. Reduce the amount of cargo, if possi-
ble.
. Stop towing a trailer as soon as
possible.
The malfunction indicator lamp may stop
blinking and illuminate steadily after sev-
eral driving trips. We recommend that you
have your vehicle checked by an author-
ized SUBARU dealer immediately.
! Vehicles NOT equipped with OBD
system
S03AE2602
If the malfunction indicator lamp illumi-
nates when the engine is running, it may
indicate that there is a problem some-
where in the engine control system.
If the light illuminates while driving or does
not turn off after the engine starts, we
recommend that you contact your nearest
SUBARU dealer immediately.
& Coolant temperature
low indicator light (if
equipped)/Coolant tem-
perature high warning
light (if equipped)
S03AE48
CAUTION
. After turning the ignition switch
to the “ON” position, if this
indicator light/warning light
shows any of the following con-
ditions, the electrical system may
be malfunctioning. We recom-
mend that you contact your
SUBARU dealer immediately for
an inspection.
– It remains blinking in RED.
– It remains illuminated in RED
for more than 2 seconds.
– It remains blinking in RED and
BLUE alternately.
. While driving, if this indicator
light/warning light shows any of
the following conditions, take the
specified appropriate measure
listed below.