Black plate (341,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
a chime (ding) will sound, and the opera-
tion indicator on the push-button ignition
switch will illuminate in green.
6. Within 5 seconds after the operation
indicator illuminates in green, while de-
pressing the brake pedal (all models) and
the clutch pedal (MT models), press the
push-button ignition switch.
NOTE
If the engine does not start even
though the above procedure was fol-
lowed precisely, we recommend that
you contact your SUBARU dealer.
Rear gate – if the rear gate
cannot be opened
S09AG
In the event that you cannot open the rear
gate by operating the power door locking
switches, keyless access function or
remote keyless entry system, you can
open it from inside the cargo area.
1. Remove the access cover at t he
bottom-center of the rear gate trim.
NOTE
For models with the double locking
system, the rear gate lock release lever
is still shielded with an anti-theft cover.
So, remove the anti-theft cover using a
Phillips screwdriver to access the rear
gate lock release lever.
2. Locate the rear gate lock release lever
behind the rear gate trim panel.
CAUTION
Never operate the rear gat e lock
release lever with fingers because
doing so may cause an injury. Al-
ways use a flat-head screwdriver or
a similar tool.
3. Slide the lever to the right to unlock the
rear gate.
4. Open the rear gate from outside by
holding the rear gate with your hands.
In case of emergency 9-17
9
To Next Page
Loading...
