Black plate (298,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
7-38 Starting and operating
To resume the cruise control after it has
been temp orarily canceled, push the
“RES/ACC” button. The vehicle will return
to the original cruising speed automati-
cally and the cruise control set indicator
light on the combination meter will illumi-
nate.
NOTE
If the vehicle speed has lowered below
approximately 32 km/h (20 mph), the
previously set cruising speed has been
canceled completely so that resetting
of the cruising speed is required.
& To turn off the cruise control
S07AQ03
There are two ways to turn off the cruise
control:
. Push the “CRUISE” main switch button
again.
. Turn the ignition switch to the “Acc” or
“LOCK”/“OFF” position (but only when the
vehicle is completely stopped).
& To change the cruising speed
S07AQ04
! To increase the speed (by button)
S07AQ0405
Push the “RES/ACC” button and hold it
until the vehicle re aches the desired
speed. Then, release the button. The
vehicle speed at that mo ment will be
memorized and treated as the new set
speed.
When the difference between the actual
vehicle speed and the set speed is less
than 4.4 km/h (3 mph), the set speed can
be increased 1 km/h (0.6 mph) each time
by pressing the “RES/ACC” button quickly.
! To increase the speed (by accel-
erator pedal)
S07AQ0402
1. Depress the accelerator pedal to
accelerate the vehicle to the desired
speed.
2. Push the “SET/COAST” button once.
Now the desired speed is set and the
vehicle will keep running at that speed.
NOTE
If the difference between the actual
vehicle speed when the button is
pushed and the speed last time you
set is less than 4.4 km/h (3 mph), the
vehicle speed will be lowered by 1 km/h
(0.6 mph). This occurs because the
cruise control system unit regards this
operation as that intended to decrease
the vehicle speed.
To Next Page
Loading...
