Black plate (275,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
is consequently increased.
. Do not engage the clutch (i.e.,
release the clutch pedal) sud-
denly when starting the vehicle.
By doing so, the vehicle might
unexpectedly accelerate or the
transmission could malfunction.
CAUTION
Shift into reverse ONLY when the
vehicle has completely stopped. It
may cause damage to the transmis-
sion to try shifting into reverse when
the vehicle is moving.
& Shifting speeds
S07AW01
! Recommended shifting speeds
S07AW0101
The best compromise between fuel econ-
omy and vehicle pe rformance during
normal driving is ensured by shifting up
at the speeds listed in the following table.
Shift up km/h (mph)
1st to 2nd 24 (15)
2nd to 3rd 40 (25)
3rd to 4th 64 (40)
4th to 5th 72 (45)
5th to 6th 80 (50)
! Maximum allowable speeds
S07AW0102
The following table shows the maximum
speeds that are possible with each gear.
The tachometer’s needle will enter the red
area if these speeds are exceeded.
With the exception of cases where sudden
acceleration is required, the vehicle
should not be driven with the tachometer’s
needle inside the red area. Failure to
observe this precaution can lead to
excessive engine wear and poor fu el
economy.
Gear km/h (mph)
1st 38 (23)
2nd 75 (46)
3rd 125 (77)
4th 169 (105)
5th 209 (129)
6th Top speed
Never exceed posted speed limits.
WARNING
When shifting down a gear, ensure
that the vehicle is not travelling at a
speed exceeding the maximum al-
lowable speed for the gear which is
about to be selected. Failure to
observe this precaution can lead to
engine over-revving and this in turn
can result in engine damage.
In addition, sudden application of
engine brakes when the vehicle is
travelling on a slippery surface can
lead to wheel locking; as a conse-
quence, control of the vehicle may
be lost and the risk of an accident
increased.
Starting and operating 7-15
– CONTINUED –
7
To Next Page
Loading...
