Black plate (35,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
& Head restraint adjustment
S01AA04
1) Head restraint
2) Release button
Both the driver ’s seat and the front
passenger’s seat are equipped with head
restraints.
The head restraint should be adjusted so
that the center of the head restraint is
closest to the top of the occupant’s ears.
To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while
pressing the release button on the top of
the seatback.
To remove:
While pressing the release button, pull out
the head restraint.
To install:
Install the head restraint into the holes that
are located on the top of the seatback until
the head restraint locks.
WARNING
. Never drive the vehicle with the
head restraints removed because
they are designed to reduce the
risk of serious neck injury in the
event that the vehicle is struck
from the rear. Therefore, when
you remove the head restraints,
you must reinstall all head re-
straints to protect vehicle occu-
pants.
. No occupants, including the dri-
ver, should sit in any seat of the
vehicle until the head restraints
are placed in their proper posi-
tions in order to minimize the risk
of neck injury in the event of a
crash.
& Active head restraint
S01AA05
The fro nt se ats of your vehicle are
equipped with active head restraints. They
tilt forward slightly in the event the vehicle
is struck from the rear, decreasing the
amount of rearward head movement and
thus reducing the risk of whiplash. For
maximum effectiveness, the head restraint
should be adjusted so that the center of
the head restraint is closest to the top of
the occupant’s ears.
Seat, seatbelt and SRS airbags 1-5
– CONTINUED –
1
To Next Page
Loading...
