Black plate (223,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
Bluetooth
®
audio (type D and
E audio)
S05BH
This function enables you to play back
audio sources from Bluetooth
®
audio
devices. You need to register the Blue-
tooth
®
audio device in the system before
using it.
NOTE
The Bluetooth word mark and logo are
registered trademarks of Bluetooth
SIG, Inc.
& Media format
S05BH01
Bluetooth
®
audio devices cannot be
connected if they are not compatible with
the following Bluetooth
®
profiles.
. A2DP (Advanced Audio Distribution
Profile)
. AVRCP (Audio/Video Remote Control
Profile)
& Setting Bluetooth
®
audio
S05BH02
1. Select “BT-A SETUP” by pressing the
“MENU” button (type D audio)/Select “BT
Audio Setup” by operating the “TUNE/
TRACK” dial (type E audio).
2. Perform the following procedure by
operating the “TUNE/TRACK” dial while
“BT-A” (type D audio)/“BT Audio” (type E
audio) is displayed.
NOTE
You cannot set a Bluetooth
®
audio
while driving.
! Registering (pairing) device
S05BH0201
1. Select the “PAIR AUDIO” (type D
audio)/“Pair Audio Player” (type E audio)
menu. If a device is already registered,
“MEMORY FULL” is displayed and the
mode changes to the Bluetooth
®
audio
setting mode.
2. After the passkey is shown on the
display, input the passkey into the device.
If you input the correct passkey, “PAIRED”
is displayed and the registering procedure
is finished. If you input an incorrect
passkey, “FAILED” is displayed, the re-
gistering procedure was not successful
and the mode changes to the Bluetooth
®
audio setting mode.
NOTE
After the ignition switch is turned to the
“LOCK”/“OFF” position, the registered
device is not automatically connected
to the system even if the ignition switch
is turned to the “Acc” or “ON” position.
! Selecting device
S05BH0202
1. Select the “SELECT AUDIO” (type D
audio)/“Select Audio Player” (type E
audio) menu. If no devices are registered,
“EMPTY” is displ ayed and the mode
changes to the Bluetooth
®
audio setting
mode.
2. Select the “CONFIRM ” menu. If the
device is connected, “SELECTED” is
displayed and the selecting procedure is
finished. If the device cannot be con-
nected, “FAILED” is displayed and the
selecting procedure was not successful.
! Setting passkey
S05BH0203
1. Select the “SET PASSKEY” menu.
After the currently set passkey is dis-
played, a new passkey can be entered.
2. Input the new passkey by operating
the “TUNE/TRACK” dial.
Audio 5-37
– CONTINUED –
5
To Next Page
Loading...
