Black plate (127,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
& Meter needles/gauge illumi-
nation setting (models with
type A, B and C combination
meter)
S03AD13
When the setting is activated or deacti-
vated, the meter needles and gauge
illuminate and turn off as follows.
Activated:
When the driver’s door is opened while
the ignition switch is in the “LOCK”/“OFF”
position, the needles and gauge illuminate
and turn off after approximately 20 sec-
onds.
When the ignition switch is turned from the
“ON” position to the “LOCK”/“OFF” posi-
tion, the illumination turns off gradually.
Deactivated:
The needles and gauge do not illuminate
when the driver’s door is opened while the
ignition switch is in the “LOCK”/“OFF”
position. The illumination turns off imme-
diately when the ignition switch is turned
from the “ON” position to the “LOCK”/
“OFF” position.
NOTE
. Even during the illumination after
the driver’s door is opened, if the
ignition switch is turned to the “ON”
position, the combination meter will
illuminate as usual.
. If the doors are locked by the key-
less access function or the remote
keyless entry system during the illumi-
nation after the driver’s door is opened,
the illumination will be turned off.
. Even while the illumination is gra-
dually turned off after the ignition
switch is turned to the “LOCK”/“OFF”
position, if the ignition switch is turned
to the “ON” position, the combination
meter illuminate as usual.
To change the setting:
1. Turn the ignition switch to the “LOCK”/
“OFF” or “Acc” position.
2. Press the trip knob to show “ ” or
“
” on the trip meter display. The display
can be switched as shown in the following
sequence by pressing the trip knob.
*: “ ” or “ ”, and “ ” or “ ” cannot
be displayed when the ignition switch is
in the “ON” position.
3. To change the current setting, press
the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
The initial illumination setting of the
meter needles/gauge of your vehicle
has been set for activation “
” at the
time of shipment from the factory.
& Speedometer
S03AD03
The speedo meter shows the vehicle
speed.
! Speed warning chime (if equipped)
S03AD0301
When the speed is over approximately
120 km/h (75 mph), a chime sounds.
Instruments and controls 3-9
– CONTINUED –
3
To Next Page
