Black plate (404,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
11-54 Maintenance and service
The fuse puller is stored in the main fuse
box in the engine compartment.
1) Good
2) Blown
If any lights, accessories or other electrical
controls do not operate, inspect the
corresponding fuse. If a fuse has blown,
replace it.
1. Turn the ignition switch to the “LOCK”/
“OFF” position and turn off all electrical
accessories.
2. Remove the cover.
3. Determine which fuse may be blown.
Look at the back side of each fuse box
cover and refer to “
s12abFuses and circuits”
F12-14.
4. Pull out the fuse with the fuse puller.
5. Inspect th e fuse. I f it has blown,
replace it with a spare fuse of the same
rating.
6. If the same fuse blows again, this
indicates that its system has a problem.
We recommend that you contact your
SUBARU dealer for repairs.
Installation of accessories
S11BD
We recommend that you always consult
your SUBARU dealer before installing fog
lights or any other electrical equipment in
your vehicle. Such accessories may
cause the electronic system to malfunc-
tion if they are incorrectly installed or if
they are not suited for the vehicle.
Also, we recommend that you always
consult your SUBARU dealer before
installing a radio in your vehicle.
To Next Page
Loading...
