Subaru FORESTER 2012 - Windshield Wiper and Washer Switches

Black plate (163,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
depressed at least for 1 second so that
washer solution will be sprinkled all
over the windshield or rear window.
. Grease, wax, insects or other mate-
rial on the windshield or the wiper
blade results in jerky wiper operation
and s treaking on the glass . If you
cannot remove those streaks afte r
operating the washer or if the wiper
operation is jerky, clean the outer sur-
face of the windshield or rear window
and the wiper blades using a sponge or
soft cloth with a neutral detergent or
mild abrasive cleaner. After cleaning,
rinse the window gl ass and wiper
blades with clean water. The glass is
clean if no beads form on the glass
when you rinse with water.
. If you cannot eliminate the streaking
even after following this procedure,
replace the wiper blades with new
ones. For replacement instructions,
refer to “
s11azReplacement of wipe r
blades” F11-47.
& Windshield wiper and washer
switches
S03AM01
The wipers operate only when the ignition
switch is in the “ON” or “Acc” position.
! Windshield wipers
S03AM0101
OFF: Off
: Intermittent
LO: Low speed
HI: High speed
To turn the wipers on, push the wiper
control lever down.
To turn the wipers off, return the lever to
the “OFF” position.
! Wiper intermittent time control
S03AM0103
When the wiper switch is in the “ ”
position, turn the dial to adjust the operat-
ing interval of the wipers.
The operating interval can be adjusted in
nine steps.
Instruments and controls 3-45
– CONTINUED –
3