EasyManua.ls Logo

Subaru FORESTER 2012 - LO Position Indicator Light (Dual Range MT Models); Turn Signal Indicator Lights; High Beam Indicator Light; Cruise Control Indicator Light (if Equipped)

Subaru FORESTER 2012
445 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Black plate (150,1)
Model "A8170GE-A" EDITED: 2011/ 7/ 3
3-32 Instruments and controls
This indicator shows the position of the
select lever.
When the manual mode is selected, the
gear position indicator (which shows the
current gear selection) and the upshift/
downshift indicator light up. Refer to
s07atAutomatic transmission F7-18.
& LO position indicator
light (dual range MT
models)
S03AE32
This light illuminates when Hi-Lo select
lever is set at Lo position.
& Turn signal indicator
lights
S03AE20
These lights show the operation of the turn
signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, any of the turn signal light bulbs
may be burned out. Replace the bulb as
soon as possible. Refer to
s11beReplacing
bulbs F11-55.
& High beam indicator
light
S03AE21
This light shows that the headlights are in
the high beam mode.
This indicator light also illuminates when
the headlight flasher is operated.
& Cruise control indica-
tor light (if equipped)
S03AE22
This light illuminates when the CRUISE
main switch is pressed.
NOTE
. If you press the CRUISE mai n
switch button while turning the ignition
switch to ON, the cruise control
function is deactivated and the cruise
control indicator light flashes. To re-
activate the cruise control function,
turn the ignition switch back to the
Acc or LOCK/OFF position, and
then turn it again to the ON position.
. If this indicator light and the mal-
function indicator lamp
flash
simultaneously during driving, we re-
commend that you have the vehicle
checked by your nearest SUBARU
dealer.
& Cruise control set in-
dicator light (if
equipped)
S03AE23
This light illuminates when vehicle cruising
speed has been set.
& Headlight indicator
light
S03AE24
This indicator light illuminates when the
light control switch is placed in the
or
position.
& Front fog light indicator
light (if equipped)
S03AE25
This indicator light illuminates while the
front fog lights are illuminated.
& Rear fog light indicator
light (if equipped)
S03AE34
This indicator light illuminates while the
rear fog lights are illuminated.
& Preheating indicator
light (diesel engine
models)
S03AE56
The preheating indicator light illuminates
when the ignition switch is turned to the
ON position and turns off after the
engine has sufficiently preheated (a few
seconds later).
NOTE
. When the weather is cold outside,
the preheating indicator light remains
illuminated a little longer than usual.
. For models without push-button

Table of Contents

Other manuals for Subaru FORESTER 2012

Related product manuals