Black plate (156,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
3-38 Instruments and controls
CAUTION
. Use of any lights for a long period
of time while the engine is not
running can cause the battery to
discharge.
. Before leaving the vehicle, make
sure that the light control switch
is turned to the “OFF” position. If
the vehicle is left unattended for
a long time with the light control
switch set to a position other
than “OFF”, the battery may be
discharged.
& Headlights
S03AH01
To turn on the headlights, turn the knob on
the end of the turn signal lever.
first position
Front position lights, i nstrument panel
illumination, tail lights and license plate
lights are on.
second position
Headlights, front position lights, instru-
ment panel illumination, tail lights, and
license plate lights are on.
& High/low beam change (dim-
mer)
S03AH02
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light “
” on the combina-
tion meter also illuminates.
To switch back to low beam, pull the lever
back to the detent position.
& Headlight flasher
S03AH03
To flash the headlights, pull the lever
toward you. The high beam will remain
on for as long as you hold the lever. The
headlight flasher works even though the
light switch is in the “OFF” position.
When the headlights are on high beam,
the high beam indicator light “
” on the
combination meter also illuminates.
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
To Next Page
Loading...
