Black plate (292,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
7-32 Starting and operating
& Vehicle Dynamics Control
system monitor
S07AN01
Refer to “s03ae15Vehicle Dynamics Control
warning light/Vehicle Dynamics Control
OFF indicator light” F3-21 and “
s03ae14Vehi-
cle Dynamics Control operation indicator
light” F3-31.
& Vehicle Dynamics Control
OFF switch
S07AN02
Pressingtheswitchtodeactivatethe
Vehicle Dynamics Control system can
facilitate the following operations.
. Standing start on a steeply sloping
road with a snowy, gravel-covered, or
otherwise slippery surface
. Extrication of the vehicle when its
wheels are stuck in mud or deep snow
When the switch is pressed during engine
operation, the Vehicle Dynamics Control
OFF indicator light “
” illuminates. The
Vehicle Dynamics Control system will be
deactivated and the vehicle will behave
like a model not equipped with the Vehicle
Dynamics Control system. W hen t he
switch is pressed again to reactivate the
Veh icle Dynamics Control system, the
indicator light turns off.
With the Vehicle Dynamics Control system
deactivated, traction and stability en-
hancement offered by Vehicle Dynamics
Control system is unavailable. Therefore
you should not deactivate the Vehicle
Dynamics Control system except under
above-mentioned situations.
NOTE
. The Vehicle Dynamics Control sys-
tem will be activated automatically
when the engine is started.
. If the switch is held down for 10
seconds or longer, the indicator light
turns off, the Vehicle Dynamics Control
system is activated, and the system
ignores any further pressing of the
switch. To make the switch usable
again, turn the ignition switch to the
“LOCK”/“OFF” position and then re-
start the engine.
. Even when the Vehicle Dynamics
Control system is deactivated, part of
the brake control system is still active.
When the s ystem is activated, the
Vehicle Dynamics Control operation
indicator light flashes.
To Next Page
Loading...
