Subaru FORESTER 2012 - Connecting USB Storage Device; Ipod

Black plate (216,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
5-30 Audio
fire.
NOTE
. iPod
®
is a registered trademark of
Apple Inc.
. You are only permitted to personally
copy and play copyright-free material
or material that is legally permitted to
be copied and played by using an
iPod
®
and iTunes. Copyright infringe-
ment is prohibited by law.
. To check the firmware version of an
iPod
®
, connect it to a computer and
check the device manager. For further
information, see the User’s Guide that
comes with the iPod
®
. To update the firmware version of an
iPod
®
, visit the Apple Inc. website.
& Connecting USB storage de-
vice / iPod
®
S05BG04
WARNING
Do not operate an iPod
®
while
driving. Doing so may distract your
attention from driving and could
lead to an accident.
CAUTION
. If the data stored on an iPod
®
is
deleted while it is connected to
the in-vehicle system, the data
cannot be recovered.
. Do not store an iPod
®
in the
vehicle. If an iPod
®
is left in the
vehicle for a long period of time,
it may be deformed, discolored
or damaged by high temperature.
NOTE
. Even if a USB storage device or
iPod
®
is connected, it cannot be played
unless the USB/iPod
®
mode is se-
lected.
. A movie cannot be played while a
USB storage device or an iPod
®
is
connected.
. While an iPod
®
is connected, the
iPod
®
cannot be operated using the
click wheel on the iPod
®
(except some
models).
. When using an iPod
®
by connecting
it to in-vehicle equipment, the order of
the list items displayed on the in-
vehicle equipment may be different
from that on the iPod
®
. However, this
does not indicate a malfunction.
. An iPod
®
battery that is connected
to in-vehicle equipment will be charged
when the ignition switch is in the “ON”
or “Acc” position. However, activation
of the iPod
®
may be delayed if the
battery charge of the iPod
®
is low.
. If an iPod
®
does not activate after
operation, disconnect the connection
cable from the iPod
®
and reset it. For
the resetting procedure, see the User’s
Guide that comes with the iPod
®
.
. If an iPod
®
and the connection cable
are connected improperly, the iPod
®
cannot be powered on or will not be
recognized by in-vehicle equipment. In
this case, disconnect the connection
cable from the iPod
®
, and then connect
it again.
The USB connector is located in t he
center console. Use the connector t o