Subaru FORESTER 2012 - Immobilizer Indicator Light; Key Replacement; Door Locks; Locking and Unlocking from the Outside with Key

Black plate (92,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
2-4 Keys and doors
& Immobilizer indicator
light
S02AB02
Refer to “s03ae28Immobilizer indicator light”
F3-31.
& Key replacement
S02AB03
Your key number plate and security ID
plate are required if you need a new
replacement key. Any new key must be
registered to your vehicle’s immobilizer
system. Up to four keys can be registered
for use with one vehicle.
For security, all the keys must be re-
registered to your vehicle’s immobilizer
system when registering a new key.
Therefore, all of your vehicle’s keys must
be presented when a new key is regis-
tered. Any key that is not re-registered
cannot be used after the other keys are re-
registered. For information on replace-
ment keys and on the registration of keys
with your immobilizer system, we recom-
mend that you contact your SUBARU
dealer.
Door locks
S02AC
& Locking and unlocking from
the outside with key
S02AC04
! Models without double locking
system
S02AC0401
To lock the driver’s door from the outside
with the key, turn the key toward the rear.
To unlock the door, turn the key toward the
front.
Pull the outside door handle to open an
unlocked door.
NOTE
Only the driver’s door is locked or
unlocked by this action.
To lock all the doors including the rear
gate, perform the following procedure.
1. Remove the key from the ignition
switch (models without keyless access
with push-button start system) or turn
off the ignition switch (models with
keyless access with push-button start
system).
2. Close the doors including the rear
gate except for the driver’s door.
1) Lock
2) Unlock
3. Push the lock side of the power door
locking switch that is located on the
driver’s door.
4. Close the driver’s door and insert the
key. Turn the key rearward to lock the
driver’s door.