Black plate (134,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
3-16 Instruments and controls
Driver ’s war ning light (t ype D and E
combination meter) (except Latin America
models)
Front passenger’s warning light (Australia
models)
! Latin America models
S03AE0105
Your vehicle is not equipped with any
seatbelt warning devices. Before driving
your vehicle, make sure that the seatbelts
are fastened properly.
! Australia models
S03AE0103
Your vehicle is equipped with a seatbelt
warning device at the driver’s and front
passenger’s seat.
With the ignition switch turned to the “ON”
position, this device reminds the driver
and front passenger to fasten their seat-
belts by illuminating the warning lights
shown in the illustrations.
If the vehicle is driven at a speed no
higher than approximately 20 km/h (12.5
mph) with the driver’s seatbelt and/or
passenger’s sea tbelt not fastene d, the
warning light(s) corresponding to the un-
fastened seatbelt(s) will illuminate con-
tinuously.
If the vehicle subsequently reaches a
speed of approximately 20 km/h (12.5
mph) with the driver’s seatbelt and/or
passenger’s sea tbelt not fastene d, the
warning light(s) will start a repeated cycle
consisting of 5 seconds of flashing fol-
lowed by 1 second of continuous illumina-
tion. At the same time, a chime will start a
repeated cycle consisting of 5 seconds of
sounding followed by a 1-second pause. If
either of the unfastened seatbelts is
fastened at this time, the warning light
corresponding to that seatbelt will imme-
diately turn off but the chime will continue
operating unless the remaining seatbelt is
fastened. This condition (continued opera-
tion of the chime unless the remaining
seatbelt is fastened) will continue for
approximately 108 seconds.
NOTE
. If the driver’s and passenger’s seat-
belts are not fastened simultaneously
(if one seatbelt is fastened significantly
earlier or later than the other), the
chime may sound longer (10 seconds
maximum).
. The occupant detection system of
the front passenger’s seat detects the
passenger by the weight on the seat.
Therefore, if there is a heavy object on
the seat, the warning system to fasten
the seatbelt is activated.
. If you use a cushion on a passen-
ger’s seat, there is the possibility that
the occupant detection system cannot
detect the passenger.
If the driver’s seatbelt and/or the passen-
ger’s seatbelt is still not fastened when the
108-second period has elapsed, the warn-
ing light(s) will stop flashing and the chime
To Next Page
Loading...
