Black plate (267,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
tance.
6. Confirm that all warning and indicator
lights have turned off after the engine has
started. The fuel injection system auto-
matically lowers the idle speed as the
engine warms up.
! Diesel engine models
S07BD010102
1. Apply the parking brake.
2. Turn off unnecessary lights and ac-
cessories.
3. Depress the clutch pedal to the floor
and shift the shift lever into neutral. Hold
the clutch pedal to the floor while starting
the engine.
4. Turn the ignition switch to the “ON”
position and check the operation of the
warning and indicator lights. At this time,
confirm that the preheating indicator light
has illuminated for a few seconds and has
turned off. Refer to “
s03aeWarning and
indicator lights” F3-14.
5. Turn the ignition switch to the “START”
position without depressing the accelera-
tor pedal. Release the key immediately
after the engine has started.
6. Confirm that all warning and indicator
lights have turned off after the engine has
started. The fuel injection system auto-
matically lowers the idle speed as the
engine warms up.
NOTE
You may feel vibration during engine
idling for several tens of seconds. This
vibration is caused by the self-learning
procedure of the injector. This learning
procedure is necessary for optimum
engine performance. This does not
indicate a malfunction.
! AT models
S07BD0102
1. Apply the parking brake.
2. Turn off unnecessary lights and ac-
cessories.
3. Shift the select lever to the “P” or “N”
position (preferably “P” position).
4. Turn the ignition switch to the “ON”
position and check the operation of the
warning and i ndicator lights. Refer to
“
s03aeWarning and indicator lights” F3-14.
5. Turn the ignition switch to the “START”
position without depressing the accelera-
tor pedal. Release the key immediately
after the engine has started.
If the engine does not start, perform the
following procedure.
(1) Turn the ignition switch to the
“LOCK” position and wait for at least
10 seconds. After checking that the
parking brake is firmly applied, turn the
ignition switch to the “START” position
while depressing the accelerator pedal
slightly (approximately a quarter of the
full stroke). Release the accelerator
pedal as soon as the engine starts.
(2) If this fails to start the engine, turn
the ignition switch back to the “LOCK”
position and wait for at least 10
seconds. Then fully depress the accel-
erator pe dal and turn the i gnition
switch to the “START” position. If the
engine starts, quickly release the
accelerator pedal.
(3) If this does not start the engine,
turn the ignition switch again to the
“LOCK” position. After waiting for 10
seconds or longer, turn the ignition
switch to the “START” position without
depressing the accelerator pedal.
Starting and operating 7-7
– CONTINUED –
7
To Next Page
Loading...
