Black plate (366,1)
一般Model "A8170GE-A" EDITED: 2011/ 7/ 3
11-16 Maintenance and service
Non-turbo models
1) Oil level gauge
2) Oil filler cap
3) Oil filter
A) ENGINE OIL
B) SEE OWNER’S MANUAL
2. Pull out the level gauge, wipe it clean,
and insert it again.
Turbo models
1) Notch
2) Full level
3) Low level
4) Approximately 1.0 liter (1.1 US qt, 0.9
Imp qt) from low level to full level
Non-turbo models
1) Full level
2) Low level
3) Approximately 1.0 liter (1.1 US qt, 0.9
Imp qt) from low level to full level
3. Be sure the level gauge is correctly
inserted until it stops. For turbo models,
the graphic symbol “
” on the top of the
gauge should be positioned as shown in
the illustration.
4. Pull out the oil level gauge again.
5. Non-turbo models:
Check the oil levels on both sides of the
level gauge. The engine oil level must be
judged by the lowest of the two levels. If
the oil level is below the low level mark,
add oil so that the full level is reached.
To Next Page
Loading...
