5-6 ENGINE REMOVAL AND INSTALLATION
INSTALLATION
Install the engine in the reverse order of removal. Pay attention
to the following points:
• Fit the swingarm in its position and hold it with the swingarm
pivot shaft.
• Mount the engine on the frame.
• Tighten the engine mounting bolts, nuts and swingarm pivot
shaft nut.
$ Tightening torque
• Install the engine sprocket
7 and snap ring
8.
# 09900-06107: Snap ring pliers
• Reassemble the drive chain clip so the slit end faces opposite
the direction of rotation.
Bolt Length
1 55 mm (2.17 in)
2 50 mm (1.97 in)
3 95 mm (3.74 in)
4 96 mm (3.78 in)
5 120 mm (4.72 in)
N·m kgf-m lb-ft
1,
3 (Bolt, Nut) 40 4.0 29.0
2 (Bolt, Nut) 45 4.5 32.5
4 (Bolt, Nut) 60 6.0 43.5
5 (Bolt, Nut) 55 5.5 40.0
6
(Shaft, Washer, Nut)
70 7.0 50.5
CAUTION
The engine mounting nut is the self-lock type and can-
not be used repeatedly. If the self-lock effect is lose,
replace it with a new one.
CAUTION
Replace the snap ring with a new one.
Seat the snap ring in the groove and locate its end as
shown in the illustration.
Sharp
edge
Thrust
To Next Page
Loading...
