Suzuki RM-Z250 - Page 94

ENGINE REMOVAL AND INSTALLATION 5-7
• Tighten the engine sprocket cover bolts to the specified
torque.
$ Engine sprocket cover bolt: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
• Install the gearshift lever in the correct position.
• Apply grease to the brake pedal pivot bolt.
% 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
• Install the brake pedal and brake pedal spring. (!19-28)
• Install the clip

9, washer and cotter pin

0.
• Install the kick starter lever in the correct position. (!8-7)
$ Kick starter lever bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Install the ignition coil/spark plug cap securely. (!2-7)
• Fit the projection of the carburetor to the depression of intake
pipe.
CAUTION
Replace the cotter pin

0 with a new one.
45 ± 10˚