2. Usage and Maintenance
Note In the above photograph, the “X” marks the location of the gamma
identification detector in the unit. The device shows the count rate bar on
the right side of the ID Mode display, which may be used to optimize the
distance to the source. Refer to section 3.2.2, p. 26 for further information.
s
The next figure illustrates the frontal dimensions and position of one of the
gamma detectors with respect to the rest of the unit.
Figure 2-12. Optimal Direction to Source (Rear) - Gamma
16 Interceptor™/en/5.1(4956)/Feb2010 ICx Technologies
To Next Page
Loading...
