Chapter 3
Operating the INTERCEPTOR™
The following chapter details the usage of the I™ and its soft-
ware to achieve optimal performance.
3.1 Modes of Operation
The table below summarizes the general relationships between the opera-
tional modes. These are explained in detail later in this manual as cited in
the sections of the listed tables. The possible default modes are denoted in
bold. Optional modes defined by hardware configuration are enclosed within
brackets. Refer to Appendix H, p. 141 for further information.
Mode General Summary Section
Level Unit displays the dose rate information in
a zero (0) to nine (9) level format.
3.3.1, p. 33
Dose Rate Monitors the dose rate. Neutron count
rate (optional) may also be displayed in
the selected units of measure.
3.2.1, p. 24
Finder† Count rate display with scrolling history
chart to allow positioning of source.
3.2.1, p. 24
Timer/
Counter
Displays additional accumulated measure-
ment results.
3.3.2, p. 34
(ID) Used to acquire a spectrum for nuclide
identification purposes.
3.2.2, p. 26
to be continued. . .
Thermo Fisher Scientific Interceptor™/en/5.1(4956)/Feb2010 21
To Next Page
Loading...
