4.12. Device Configuration
Warning The headset pin is used for the entire communication between the
headset and the unit while using the Bluetooth® wireless technology. s
OBEX settings for a device equipped with Bluetooth wireless technology:
• “Enable OBEX” enables the OBEX File Transfer Service in read only
mode. specification.
• “Allow write” enables write permissions for the OBEX File Transfer
Service. This key only works in combination with “Enable OBEX”.
Bluetooth® GPS Settings:
• “Enable Bluetooth GPS settings” turns this service on. If turned off,
communications to the Bluetooth® GPS module is not possible.
• “Bluetooth address” for the Bluetooth® GPS module is preset at the
factory for the Bluetooth® GPS unit that is supplied with a GPS-
enabled I™. This address can be found by utilizing a
Bluetooth® connection between a host PC and the GPS receiver and
examining the properties of the receiver.
Warning The Bluetooth GPS settings are only visible for an I-
™ that has been factory enabled for this option. s
Remarks on IP settings:
• The I™ unit’s IP’s and the PC interface IP using the Blue-
tooth® specification must exist within the same subnet. (The PC Soft-
ware will verify this setting.) If the user changes the PC interface IP
address, then make sure that all other device IP addresses are changed
to prevent conflicts that will make communication impossible.
• If the same IP address is used for several I™ units, simul-
taneous communication with these units will not be possible.
4.12.5 Utilizing Bluetooth® Reach-Back (Optional)
Warning All settings on this page require a power cycle of the I-
™ to become active! s
Thermo Fisher Scientific Interceptor™/en/5.1(4956)/Feb2010 83
To Next Page
Loading...
