4. PC Software
General settings for the I™ with Bluetooth® technology:
• “Enable Bluetooth” activates this feature. If this is turned off, all other
functionality using Bluetooth® technology is disabled. The factory
default is “ON”.
Device network settings using the Bluetooth® technology:
• “Enable Bluetooth Network Connections” turns this service on. If
turned off, no PAN connection to the PC is possible. The factory de-
fault is “ON”.
• “Network Pin” for the I™ uses one pin for all functions
using the Bluetooth® technology. It has to be entered using the head-
set pin field. The factory default is “0000”.
• “Device IP” sets the IP address of the I™ device.
See remarks below for proper settings. The factory default is
“192.168.211.2”
PC network settings for Bluetooth® technology:
• Use the drop down box to select the option for Bluetooth® specifica-
tion. There is no factory default.
• “Interface IP” specifies the interface IP address for the selected interface
on the PC.
Warning Pressing the “save” button will change the IP settings of the se-
lected PC interface. Do not select another interface, since this could change
your networking settings to undesired values and prevent proper connection
to the network or the Internet. s
Settings for a headset using Bluetooth® wireless technology:
• Enter the “Headset pin” of the headset desired for use with the I-
™. This pin is also used for all other communications using the
Bluetooth® specification.
82 Interceptor™/en/5.1(4956)/Feb2010 ICx Technologies
To Next Page
Loading...
