Thermo Interceptor - Modes of Operation - Bluetooth GPS Mode (User Input); Modes of Operation - Bluetooth GPS Mode (Valid GPS)

3.4. Bluetooth® GPS Mode (Optional)
Figure 3-38. Modes of Operation - Bluetooth® GPS Mode (User Input)
pleted identification screen will indicate that the GPS coordinates are valid.
Figure 3-39. Modes of Operation - Bluetooth® GPS Mode (Valid GPS)
If the unit has found a Bluetooth® GPS signal but the Bluetooth® GPS is
not receiving a satellite signal, the completed identification screen will indi-
cate that the GPS unit is not detecting any satellites.
If the unit cannot obtain a signal from the Bluetooth® GPS module, the
completed identification screen will indicate that it cannot find the GPS
module:
The following are excerpts from the I™ Sync Software event
reports from a GPS-enabled I™ that illustrate valid and invalid
GPS coordinates during the identification:
Thermo Fisher Scientific Interceptor™/en/5.1(4956)/Feb2010 47