4.3. Before Getting Started
4. Select Start|Control Panel|System,
5. Select Device Manager,
6. Select Mobile Devices|Microsoft USB Sync (if there are other devices
listed, make sure they are disconnected from the PC,
7. Right-click Microsoft USB Sync and select “Properties”; then select the
Driver tab,
8. Click “Update Driver”,
9. Click “Browse my computer for driver software”,
10. Click the “Browse” button and drill down to the Microsoft Vista
Drivers folder on the I™ Sync installation CD-ROM and
then click “Let me pick from a list of device drivers on my computer”,
11. Click “Have Disk” and drill to the Microsoft Vista Drivers folder on
the I™ installation CD-ROM,
12. Select the driver file “wceusbsh” and click “Open” to install the driver,
13. After the driver is installed, return to the Control Panel and open the
Mobile Device Center,
14. Uncheck both the “Allow USB connections” and “Allow connections to
one of the following:” boxes.
You are now ready to begin using I™ Sync on your Microsoft
Vista PC.
Warning The driver downgrade described above must be performed for
each USB port that will have an I™ connected to it. s
Warning There can be conflicts with other Microsoft USB Sync devices
that may require you to manually toggle the settings in the Windows Mobile
Device Center located within the Control Panel. s
4.3 Before Getting Started
The provided PC software requires Microsoft.NET™ Version 2.0 Frame-
work and Microsoft® ActiveSync® Version 4.1 or later. Pre-installation of
Thermo Fisher Scientific Interceptor™/en/5.1(4956)/Feb2010 57
To Next Page
Loading...
