Toshiba e-studio 6560c - Error Code “M00” Is Displayed While Updating Firmware

8
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8 - 293
8.4.16 Error code “M00” is displayed while updating firmware
Check item Measures
Switching regulator • Connector check (CN404, CN405)
• Harness check
• Fuse check (F210)
LGC board • Board check
• Connector check (CN301, CN302)
• Harness check
Replace parts Remarks
Switching regulator
LGC board