Toshiba e-studio 6560c User Manual

8
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8 - 345
8.5.32 Low density image (rear side)
Fig.8-44
1) Confirmation
This phenomenon may occur when a large amount (10 K sheets or more) paper with a high printing
ratio (85% or higher) are being printed continuously.
When the image shown above appeared (the image area approx. 5 cm from the rear end is light or light
diagonal lines appear over the entire image), the developer material in the developer unit may greatly
increase. In this case, take out the developer unit of the same color as the image and then take off the
developer upper unit to check the amount of the developer material on the transport section under the
developer sleeve. If the amount of the developer material is extremely large, scoop up the developer
material with a sheet of paper or similar until the amount becomes proper.
After checking the amount, investigate the following:
2) Investigating cause / taking measures
If the developer material has greatly increased
(rear side)
The amount of the developer material is proper
(rear side)
Fig.8-45 Fig.8-46
Feeding direction
Developer material
Developer material

Toshiba e-studio 6560c Specifications

General

Functions	Print, Copy, Scan, Fax
Print Speed (Black)	Up to 65 ppm
Print Speed (Color)	Up to 65 ppm
Copy Speed (Black)	Up to 65 cpm
Copy Speed (Color)	Up to 65 cpm
Copy Resolution	600 x 600 dpi
Duplex Printing	Yes
Scan Resolution	Up to 600 dpi
Connectivity	Ethernet
Operating System Compatibility	Linux