Toshiba e-studio 6560c - Exit Paper Cooling Fan (Rear)

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 202
4.9.20 Exit paper cooling fan (rear) (F15)
(9) Remove 2 screws and take off the bracket [1]
of the pressure roller contact/release clutch.
(10) Loosen 2 screws [2] and take off the
pressure roller contact/release clutch.
Notes:
When installing, align the shaft chamfering
section with the hole.
Fig. 4-585
Notes:
When installing the shaft to the clutch, pay
attention to the following points.
• Fix the shaft [2] with the screws so that the
edge of the clutch [1] is between the
grooves in the shaft.
A: Correct installation position
B, C: Separated from the grooves
• When fixing the shaft, tighten 2 screws [3]
securely with a hexagon wrench.
Fig. 4-586
(1) Take off the fuser unit.
 P. 4-172"4.9.1 Fuser unit"
(2) Open the SYS board case.
 P. 9-2"9.1.3 SYS board case"
(3) Release a harness from 2 clamps.
Fig. 4-587
[
1
]
[
2
]
[
1
]
[
2
]
[
3
]
A
BC