Toshiba e-studio 6560c - TRU Waste Toner Transport Motor

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 161
4.7.22 TRU waste toner transport motor (M11)
(5) Remove 1 clip to remove the waste toner
receiving inlet.
Fig. 4-471
(6) Disconnect 1 connector and remove 2
screws. Then take off the TRU waste toner
auger drive section [1].
Fig. 4-472
(1) Take off the TRU waste toner auger drive
section.
 P. 4-160"4.7.21 TRU waste toner auger
drive section"
(2) Remove 2 screws and then take off the TRU
waste toner transport motor.
Notes:
Pay attention to the size (length) of the
screws. If incorrect ones are used, the motor
could be damaged.
Fig. 4-473
Waste toner receiving inlet
Clip
[
1
]
Screw
TRU waste toner transport motor