Toshiba e-studio 6560c - Pressure Roller Contact;Release Sensor

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 194
4.9.14 Pressure roller contact/release sensor (S48)
(1) Take off the pressure roller cover.
 P. 4-173"4.9.2 Pressure roller cover"
(2) Remove 1 screw and take off the sensor
bracket [1].
Fig. 4-562
(3) Remove the film from the sensor bracket [1].
(4) Take off the pressure roller contact/release
sensor [2] and disconnect the connector.
Fig. 4-563
[
1
]
[
1
]
[
2
]