Toshiba e-studio 6560c - Reading Start Roller

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 272
4.11.18 Reading start roller
(4) Remove 1 E-ring and 1 bushing (front side).
Slide the intermediate transport roller,
remove 1 pulley and 1 bushing, and take off
the intermediate transport roller.
Notes:
When installing the intermediate transport
roller, refix the loosened screw and tighten
the belt tension.
Fig. 4-793
(1) Take off the reading start guide unit.
 P. 4-263"4.11.10 Reading start guide unit"
(2) Loosen 1 screw.
Fig. 4-794
(3) Remove 1 screw. Remove 1 timing belt, 1
pulley and 1 bearing.
Fig. 4-795
Intermediate transport roller
Bushing
E-ring
Bushing
Pulley
Bearing
Pulley