Toshiba e-studio 6560c - Pressure Roller;Pressure Roller Heater Lamp (LAMP)

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 178
4.9.8 Pressure roller / Pressure roller heater lamp (LAMP)
(11) Remove 2 screws, and take off screw cover
[2] from separation plate [1].
(12) Take off the separation plate [1].
(13) Take off the plate [3].
Fig. 4-512
(14) Remove 2 springs [2] from separation plate
[1].
Fig. 4-513
(1) Take off the pressure roller cover.
 P. 4-173"4.9.2 Pressure roller cover"
(2) Take off the transport guide-1.
 P. 4-174"4.9.3 Transport guide-1"
(3) Take off the rear plate.
 P. 4-176"4.9.7 Separation plate"
(4) Take off the entrance guide cover.
 P. 4-175"4.9.5 Entrance guide cover"
(5) Take off 2 links.
 P. 4-176"4.9.7 Separation plate"
(6) Remove 1 screw and take off the bracket [1]
of pressure roller contact / release detection
sensor.
Fig. 4-514
[
1
]
[
2
]
[
2
]
[
3
]
[
3
]
[
1
]
[
2
]
[
2
]
[
1
]