6
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
SETTING ADJUSTMENT
6 - 93
6.8.3 Adjustment of the doctor-sleeve gap
For the adjustment of the doctor-sleeve gap, perform the same procedure for the Y, M, C and K
developer units.
Adjustment tool to use: Doctor-sleeve gap jig
<Adjustment procedure>
(1) Take off the developer unit from the
equipment.
(2) Discharge the developer material.
(3) Loosen 2 doctor blade fixing screws. Insert
the gauge “0.65” of the doctor sleeve jig
between the developer sleeve and doctor
blade (3 points) to adjust the gap, and tighten
the screws.
Adjustment standard: 0.65 +/- 0.05mm
Fig.6-52
Notes:
1. Flip up the protection sheet for the doctor
blade from the sleeve before inserting the
gauge. Also, be sure not to damage the
protection sheet.
2. When confirming and adjusting the gap
between the developer sleeve and the
doctor blade, insert the gauges into the
gap after rotating the developer sleeve so
that its marking faces the doctor blade.
Fig.6-53
Fig.6-54
Doctor blade
Doctor-sleeve gap jig
Doctor-sleeve gap jig
Protection sheet
Marking
Doctor blade
To Next Page
Loading...
