Toshiba e-studio 6560c - Transfer Belt Paper Clinging Detection Sensor

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 78
4.5.48 Transfer belt paper clinging detection sensor (S47)
Notes:
Match the boss of the gear with the hole of
the cover when installing the motor.
Fig. 4-227
(1) Pull out the transfer belt unit.
 P. 4-139"4.7.1 Pulling out the transfer belt
unit"
(2) Remove 1 screw and slide the middle guide
and then release 2 hooks.
Fig. 4-228
(3) Disconnect 1 connector and then take off the
middle guide.
Fig. 4-229
Middle guide
Middle guide